|
American Cable & Rigging Supply, Inc.
24 Sterling Place Mills River, NC 28759
Fax (828) 654-8010
(828) 654-8000
|
|
|
|
Cable Rail
Hardware |
|
Click on the
thumbnail to see an enlarged picture. Description of the picture is
below the enlarged picture.. |
|
|
|
The
fittings shown are our most commonly sold items for cable railing
and we keep these fittings in stock. |
|
|
|
Click
here to see our Cable Rail Parts Catalog |
|
|
This is a stainless steel "threaded stud terminal" and is the most commonly used tensioner for both ends of cables. It is also the least expensive of all the terminals shown, but must be able to pass through the end posts to tension. This picture shows the hardware installed (washer, nut and dome nut).
This is another picture of the threaded stud terminal without the hardware attached.
This picture description is "Stainless Steel turnbuckle for 3/16" diameter cable rail cable"- used commonly for stairs or applications where going "through" the post is not practical. It attaches to the inside of a post and will swivel at angles. This is a Stainless steel "toggle" and is usually used in conjunction with and on the opposite end of the Stainless steel turnbuckle. It does not provide tensioning ability, but the turnbuckle end does. It also swivels for the angle of stairs.
This is a stainless steel "threaded stud terminal" and is the most commonly used tensioner for both ends of cables. It is also the least expensive of all the terminals shown, but must be able to pass through the end posts to tension. This picture shows the hardware installed (washer, nut and dome nut).
|
|
|
|
|
|
|
|
HOME PAGE
|
SEND E-MAIL
|
|
|
|
|
|
Copyright © 2009 AMERICAN
CABLE & RIGGING SUPPLY, INC.
All Rights Reserved |
|
|
|
